SODAQ ONE

SODAQ ONE-US-RN2903-V3

This is the third generation of the successful SODAQ ONE board. It comes well equipped with a solar charge controller and runs efficiently on a LiPo or a permanent battery. It has the Ublox Eva 8M GPS module which is not only super miniature, but with its assisted GPS feature it can get an accurate fix within seconds. It also features an extremely low power Accelerometer / Magnetometer. This gives the board a nifty feature where it can stay in (deep) sleep mode until it moves. An essential feature for developing low power devices.

Sodaq oneLet's imagine you want to develop a bicycle tracker using the SODAQ ONE. You would like to track the position of the bike, but only when it has moved. This is possible if you keep the device in deep sleep until it detects motion. If the motion continues for a while, the bicycle may have changed position so only then the GPS will switch on to get a new reading and send this location over the LoRa network. Efficient right? This system will allow you make most efficient use of your battery capacity by only using the GPS when really needed, essentially increasing the battery life of your system.
The board is so small (45x25 mm) you can fit it inside almost anything (Seriously, look at the picture). To ease the development, we have fitted two rows of headers, so you can use it on a breadboard. Why? Well, it has 14 free I/O lines that you can use for your own purpose. Whether you want to build a weather station, control street lights or get a signal when you have received (snail) mail. It's all possible with the SODAQ ONE.
 
New in this version is the added JST headers (receptacles) so you can now directly plug in a LiPo battery and Solar Panel.
Have questions? Contact our ITS department anytime by email, or by phone at 416-859-5036. 

Here's an overview of the features:
SpecificationsDetails 
Microcontroller ATSAMD21G18, 32-Bit ARM Cortex M0+
Compatibility

Arduino M0 Compatible

Size

45 x 25 mm

Operating Voltage

3.3V

I/O Pins

14, All can be used for digital and 12 log with PWM, UART, SPI and TWI (I2C)

Analog Output Pin

10-bit DAC

External Interrupts

Available on all pins

DC Current per I/O pin

7 mA

Flash Memory

256 KB

SRAM

32KB

EEPROM

Up to 16KB by emulation

Clock Speed

48 MHz

Debug 

Serial Wire Interface

Power

 5V USB power and/or 3.7 LiPo battery

Charging 

Solar charge controller, up to 500mA charge current

LED 

RGB LED

LoRa Microchip

RN2903A

GPS 

uBlox EVA 8M

Accelerometer/Magnetometer LSM303AGR
USB  MicroUSB Port

Stinson Owl-Lite is a Distributor for:
m
averydennison
mdiworldwide
orafol
tapco
trinityhighwayproducts
vermac
rszbonesafetysignslogo2